Maval Industries has been remanufacturing steering products for over 30 years.

• All component pieces are OE quality
• All rubber components are new, including seals, O-Rings, Teflon rings and bellows
• Salvaged components are inspected and machined to OE specificiations
• Includes solenoids and other related components (where applicable) to ensure proper vehicle perfomance
• Tested to meet OE performance

Installation Note: If o-ring between the pump and return fitting is not replaced, noise and leakage will occur. In addition, reservoir screen needs to be free of all contaminants.

Installation Tips

• Replace Power Steering Pressure and Return Hoses when replacing the power steering pump. Steering hoses can degrade internally and cause contamination in the power steering system, which can damage the new power steering pump
• Where applicable, replace the Power Steering Reservoir or clean the internal filter
• Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
• Consider replacing the Belt (found in the Belt Drive category). Modern belts wear gradually and become less efficient, which can put strain on the Power Steering Pump and other belt driven components
• Install the pump and all supplied o-ring seals according to installation instructions, to prevent leaking
• Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
• A replacement Power Steering Pump can whine or make noise until air is purged from the fluid. Bleed the system during installation to prevent noise and extend the life of the steering components