OEM specified. High strength threadlocker for heavy-duty applications 3/8 inch to 1 inch (10mm to 25mm). Especially well suited for permanently locking studs and press fits. Adds 3,000 PSI holding power on slip and press fit assemblies. Replaces set screws and snap rings. Locks against vibration loosening. May require heat or special tools for removal. Conforms to ASTM D5363 AN0221 (Mil-S- 46163A, Type I, Grade K).
Directions:
- Parts should be clean and oil free.
- Shake tube of Threadlocker well before each use.
- Remove cap and snip nozzle tip.
- Apply Threadlocker to threaded areas and assemble parts.
NOTE: Threadlocker works on metal parts. It is not recommended for plastics. Cured product must be heated to 500°F before parts will separate.
Attention California Customers - WARNING: Cancer. www.P65Warnings.ca.gov
|
