NASTRA
More Information for NASTRA 7448889
{Alternate Inventory Numbers: 7-448889}
Continue Shopping
 
NASTRA 7448889  
($44.79/Each)
Price
$37.00
Core
+ Sold in packs of 2x2
Pack
$163.58
Total
NASTRA 7448889close
<
>
Part image
Includes: Hardware
  • All units are disassembled down to the casing and steel shot blasted to ensure a thorough cleaning.
  • Only original equipment type cores are used in the rebuilding process.
  • All threads are inspected and tapped. Only new bleeder screws and copper washers are used.
  • All casting bores and seal surfaces are tested and inspected before assembly to prevent leaking and ensure a proper fit.
  • All steel pistons are tested and inspected for roundness, pitting and cracking. All good steel pistons are refurbished. Defective steel pistons are replaced with new ISO 9002 certified steel pistons.
  • All phenolic pistons are replaced.
  • All units are assembled with new ISO 9002 Certified rubber components that meet or exceed O.E. and S.A.E. standards and with the highest quality assembly fluid and silicone grease.
  • All caliper ear hardware (rubber bushings and slider sleeves) are installed.
  • All units are tested after assembly and run through a quality assurance program.
  • Hardware (bolts, clips, sleeves, springs and rubber components) and brackets are supplied and mounted where applicable.
  • All threads are inspected and tapped. Only new bleeder screws and copper washers are used.
  • All calipers are individually shrink wrapped before boxing to ensure high quality and trouble free product.
  • Brake pads pre-installed.
Installation Tips
  • Always inspect brake pads and rotors when replacing your calipers. Faulty calipers can lead to uneven pad and rotor wear
  • Inspect or change brake hoses when replacing the caliper. Worn or damaged hoses should be replaced to prevent brake fluid contamination or loss
  • Use a Brake Fluid Tester to test your brake fluid. If your brake fluid has moisture in it, flush the system before installing the new caliper
  • Apply Blue Threadlocker to caliper bracket mounting bolts to lock the bolts in place and prevent loosening or backing out
  • After installing the new caliper, bleed your brakes to ensure no air is trapped in the brake fluid. RockAuto offers a selection of Brake Bleeding Tools to help with this process
  • After the brakes have been bled, top off the master cylinder reservoir with the proper Brake Fluid

Attention California Customers - WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov


NASTRA Warranty Information:
12 months/12,000 miles