|
BBB INDUSTRIES 2010135E
|
|
$474.99
Price
|
$382.00
Core
|
+ Sold in packs of 1x1
Pack
|
$856.99
Total
|
|
|
|
|
|
| BBB Industries markets and sells their products under various brand names, including Genco, Vision-OE and Wilson. The product inside the box is the same, no matter what brand name appears on the box.
|
| BBB INDUSTRIES 2010135E Specifications |
|---|
| Connector A Pin Count | 2 Pin | | Connector B Pin Count | 3 Pin | | Control Module Included | Yes | | Hydraulic, Electric, or Manual Steering | Electric | | Inner Tie Rods Included | Yes | | Input Shaft Diameter (IN) | 0.73 | | Input Shaft Diameter (MM) | 18.542 | | Input Shaft Length (IN) | 5.04 | | Input Shaft Length (MM) | 128.016 | | Motor Included | Yes | | Mounting Hole Quantity | 2 | | New Or Remanufactured | Remanufactured | | Outer Tie Rods Included | No | | Rack Length (IN) | 55.38 | | Rack Length (MM) | 1406.652 | | Total Turns Lock To Lock | 3.75 |
|
|
BBB's Electronic Power Assist Steering (EPAS) Rack & Pinion Remanufacturing Process Includes:
- Full disassembly and inspection
- Electrically and electronically tested for input and output parameters
- New rack belt (where applicable)
- New boots and seals
Common EPAS Failures
Water Ingression- This occurs when the unit is not properly sealed and water is able to get inside the unit causing contamination, electrical problems and rust.
Belt Failure- Belt driven EPAS racks have an internal belt to transfer the torque from the electric motor to the rack bar via a ball screw assembly. The belt can wear, stretch, strip, or break causing loss of assist.
Torque Sensor Failure- The sensor gives incorrect input data to the Power Steering Control Module (PSCM) leading to improper assist and diagnostic trouble codes (DTC).
Reduced Assist- When values or inputs are not within specification the PSCM can use preprogrammed values to give reduced assist to the driver. A DTS will be set triggering the Mafunction Indicator Light (MIL).
EPAS Programming
Some EPAS units do not require programming. For those that do, these steps should be followed:
1. Vehicle system voltage must remain constant (OE specified) during the reprogram
2. Vehicle electrical system should be functioning properly
- Battery health and state of charge
- Connections are clean and cables are in good condition (voltage drop)
- Alternator charge peformance (this may require a power supply or reflashing charger, do not use a battery charger)
3. Follow all OE re-programming instructions exactly
Attention California Customers - WARNING: Cancer and Reproductive Harm
Attention California Customers - Y
|
| OEM / Interchange Numbers: 99017M, CV6Z3504AE, CV6Z3504EE, CV6Z3504ZKP |
BBB INDUSTRIES Warranty Information:3 years/36,000 miles |
|
