Centric High Carbon Alloy Rotors contain an advanced metallurgy that greatly reduces the possibility of pad squeal, especially with higher friction, European style brake pad compounds. Proprietary Molybdenum and Chromium alloys resist rotor cracking during high performance use or repeat stop situations. This alloy also increases the friction couple improving brake performance and stopping power. Increased Chromium and Carbon content is also more resistant to oxidation.
Features & Benefits:
Symmetric vane castings enable proper heat transfer and thermal efficiency, resulting in superior braking power
Black E-Coat anti-corrosive coating protects the cooling vanes and mounting surfaces from rusting prematurely
Double disc ground friction surface finish virtually eliminates run out and any disc thickness variation issues
Mill Balancing reduces rotor vibration and ensures smooth operation at all speeds
Non-directional finish for improved rotor and pad break-in
Installation Tips
Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function