FVP 92086
|
|
$7.33
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$7.33
Total
|
|
|
|
FVP 92086 Specifications |
---|
OE Comparison Rating | OE Performance | Length (IN) | 46.5 | End 1 Diameter (MM) | 16 | End 1 Type | Male O-Ring | End 2 Diameter (MM) | 18 | End 2 Type | Male O-Ring | Includes Switch Port | No |
|
|
Features:- High quality construction for long life: procote tubing, hypalon hose
- Engineered to be equal to or better than the OE design and specifications
- Includes replacement seals or gaskets, where required, to complete the job right the first time
Hydroboost uses the pressure of the Power Steering Pump to power the Brake Booster. This is denoted by a third port on the Power Steering Pump and hoses that connect the pump to a brake unit behind the master cylinder.
Installation Tips - Replace all power steering hoses at the same time, to prevent system contamination
- Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
- Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
- Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
Attention California Customers - WARNING: Using this product can expose you to 1,3Butadiene, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. Wash hands after handling. (18)
|
Warranty Information:Limited Lifetime |
|