GATES
More Information for GATES 361260
Continue Shopping
 
GATES 361260close
Part image
GATES 361260 Specifications
Bracket Bushings IncludedNo
Copper Washers IncludedNo
Crimped Sleeve MaterialAnti Corrosion Steel
End 1 Diameter (MM)16
End 1 TypeMale O-Ring
End 2 Diameter (MM)18
End 2 TypeMale O-Ring
Heat Sleeves IncludedNo
Hose PositionPump to rack/gear box
Length39"
Mounting Brackets IncludedNo
Rubber Hose StandardExceeds SAE J188 specifications
Rubber Mounts IncludedNo
Steel Tube MaterialZinc Single Wall Steel
Switch Port IncludedNo
Features:
  • Hoses come complete with factory installed, pre-bent zinc dichromate plated end fittings, sensor ports, sheathing, bushings, and grommets
  • Includes general instructions
Installation Tips
  • Replace all power steering hoses at the same time, to prevent system contamination
  • Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
  • Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
  • Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components

Attention California Customers - WARNING: Using this product can expose you to 1,3-Butadiene, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to - www.P65Warnings.ca.gov.  Wash hands after handling. (18)

OEM / Interchange Numbers: 26056831

GATES Warranty Information:
Limited Lifetime
Warranty Details