More Information for BBB INDUSTRIES 2120114E

Continue Shopping

BBB INDUSTRIES 2120114E	Out of Stock Price	Core	Pack	Total	Add to Cart

Point to Zoom

BBB Industries markets and sells their products under various brand names, including Genco, Vision-OE and Wilson. The product inside the box is the same, no matter what brand name appears on the box.

BBB INDUSTRIES 2120114E Specifications
Connector A Pin Count	2 Pin
Connector B Pin Count	3 Pin
Control Module Included	Yes
Hydraulic, Electric, or Manual Steering	Electric
Inner Tie Rods Included	Yes
Input Shaft Diameter (IN)	0.69
Input Shaft Diameter (MM)	15.878
Input Shaft Length (IN)	2.18
Input Shaft Length (MM)	55.372
Motor Included	Yes
Mounting Hole Quantity	3
New Or Remanufactured	Remanufactured
Outer Tie Rods Included	No
Rack Length (IN)	51.38
Rack Length (MM)	1305.052
Total Turns Lock To Lock	3.06

Reman

BBB's Electronic Power Assist Steering (EPAS) Rack & Pinion Remanufacturing Process Includes:

Full disassembly and inspection
Electrically and electronically tested for input and output parameters
New rack belt (where applicable)
New boots and seals

Common EPAS Failures

Water Ingression- This occurs when the unit is not properly sealed and water is able to get inside the unit causing contamination, electrical problems and rust.
Belt Failure- Belt driven EPAS racks have an internal belt to transfer the torque from the electric motor to the rack bar via a ball screw assembly. The belt can wear, stretch, strip, or break causing loss of assist.
Torque Sensor Failure- The sensor gives incorrect input data to the Power Steering Control Module (PSCM) leading to improper assist and diagnostic trouble codes (DTC).
Reduced Assist- When values or inputs are not within specification the PSCM can use preprogrammed values to give reduced assist to the driver. A DTS will be set triggering the Mafunction Indicator Light (MIL).

EPAS Programming

Some EPAS units do not require programming. For those that do, these steps should be followed:

1. Vehicle system voltage must remain constant (OE specified) during the reprogram
2. Vehicle electrical system should be functioning properly

Battery health and state of charge
Connections are clean and cables are in good condition (voltage drop)
Alternator charge peformance (this may require a power supply or reflashing charger, do not use a battery charger)

3. Follow all OE re-programming instructions exactly

Attention California Customers - WARNING: Cancer and Reproductive Harm

OEM / Interchange Numbers: 1K1423055M

BBB INDUSTRIES Warranty Information:
3 years/36,000 miles