BBB Industries fait la publicité de et vend leurs produits sous divers noms de marque, y compris Genco, Vision-OE et Wilson. Le produit à l'intérieur de la boîte est le même, peu importe le nom de marque qui apparaît sur la boîte.
Spécifications de BBB INDUSTRIES 2120114E
Connecteur A Nombre de broches
2 broches
Connecteur B Nombre de broches
Trois Broches
Module de commande inclus
Oui
Direction hydraulique, électrique, ou standard non assistée
Électrique
Biellettes de direction intérieures incluses
Oui
Diamètre de l'arbre d'entrée (pouce)
0.69
Diamètre de l'arbre d'entrée (mm)
15.878
Longueur de l'arbre d'entrée (pouce)
2.18
Longueur de l'arbre d'entrée (mm)
55.372
Moteur inclus
Oui
Quantité de trous de montage
3
Neuf ou réusiné
Réusiné
Biellettes de direction extérieures incluses
Non
Longueur de la crémaillère (pouce)
51.38
Longueur de la crémaillère (mm)
1305.052
Nombre de rotations du bout au bout
3.06
Réusiné
BBB's Electronic Power Assist Steering (EPAS) Rack & Pinion Remanufacturing Process Includes:
Full disassembly and inspection
Electrically and electronically tested for input and output parameters
New rack belt (where applicable)
New boots and seals
Common EPAS FailuresWater Ingression- This occurs when the unit is not properly sealed and water is able to get inside the unit causing contamination, electrical problems and rust. Belt Failure- Belt driven EPAS racks have an internal belt to transfer the torque from the electric motor to the rack bar via a ball screw assembly. The belt can wear, stretch, strip, or break causing loss of assist. Torque Sensor Failure- The sensor gives incorrect input data to the Power Steering Control Module (PSCM) leading to improper assist and diagnostic trouble codes (DTC). Reduced Assist- When values or inputs are not within specification the PSCM can use preprogrammed values to give reduced assist to the driver. A DTS will be set triggering the Mafunction Indicator Light (MIL).
EPAS Programming
Some EPAS units do not require programming. For those that do, these steps should be followed:
1. Vehicle system voltage must remain constant (OE specified) during the reprogram
2. Vehicle electrical system should be functioning properly
Battery health and state of charge
Connections are clean and cables are in good condition (voltage drop)
Alternator charge peformance (this may require a power supply or reflashing charger, do not use a battery charger)
3. Follow all OE re-programming instructions exactly
Attention aux clients en Californie - ATTENTION : Cancer et troubles de la reproduction
Attention aux clients en Californie - Y
Numéros de constructeur de l'équipement d'origine / numéros d'échange : 1K1423055M
BBB INDUSTRIES Informations sur la garantie:3 ans/36,000 miles